# Ladder Safety on Construction Sites

Source: https://usi.how/osha-10-construction/ladder-safety-on-construction-sites

## Choosing the Right Ladder

### Types of Ladders

1. **Stepladders**
    - Self-supporting A-frame design
    - Good for work in the center of a room
    - Never lean against a wall when closed
2. **Extension Ladders**
    - Non-self-supporting
    - Must lean against a stable structure
    - Good for reaching higher areas
    - Available in various lengths
3. **Fixed Ladders**
    - Permanently attached to a structure
    - Often found on buildings and equipment
    - May require fall protection based on height
 

### Ladder Materials

- **Wood**: Non-conductive but can deteriorate
- **Aluminum**: Lightweight but conducts electricity (never use near power lines)
- **Fiberglass**: Strong, non-conductive, but heavier
 

### Duty Ratings

Choose a ladder that can support your weight plus tools and materials:

- Type IAA: 375 lbs (Special duty)
- Type IA: 300 lbs (Extra heavy duty)
- Type I: 250 lbs (Heavy duty)
- Type II: 225 lbs (Medium duty)
- Type III: 200 lbs (Light duty - not recommended for construction)
 

## Ladder Inspection

Always inspect before use. Look for:

- Loose, broken, or missing rungs
- Loose hinges or braces
- Damaged side rails
- Missing labels
- Grease, oil, or other slippery substances
- Damage to feet or other components
 

If you find any defects, tag the ladder "Do Not Use" and report it to your supervisor.

## Setting Up a Ladder Safely

### For Stepladders:

1. Open completely and lock spreaders
2. Set on firm, level ground
3. Never stand on the top two steps
4. Keep your belt buckle between the side rails
 

### For Extension Ladders:

1. Follow the 4-to-1 rule: For every 4 feet of height, place the base 1 foot from the wall
2. Extend 3 feet above the upper landing surface
3. Secure at top and bottom when possible
4. Place on firm, level ground
5. Have a helper hold the ladder when possible
 

## Safe Ladder Use

### Three-Point Contact

Always maintain three points of contact while climbing:

- Two hands and one foot, or
- Two feet and one hand
 

### Positioning

- Face the ladder when climbing up or down
- Stay centered between the side rails
- Never lean too far to either side (keep your belt buckle between the rails)
- Never stand higher than the third rung from the top
 

### Safe Practices

- Never carry tools in your hands while climbing
- Use a tool belt or hoist tools up separately
- One person on a ladder at a time
- Don't place ladders in front of doors without blocking the door
- Keep ladders away from electrical lines (minimum 10 feet)
- Don't use ladders in high winds
- Don't stand on the top cap of a stepladder
- Don't use a stepladder as a straight ladder
- Don't place ladders on unstable bases like boxes or barrels
 

## Common Ladder Accidents and Prevention

### Tipping

- Ensure the ground is level
- Use ladder levelers if necessary
- Have a coworker hold the ladder
- Never set up on soft ground
 

### Slipping

- Ensure feet have slip-resistant pads
- Keep shoes clean
- Avoid climbing in wet or icy conditions
- Tie off the ladder when possible
 

### Electrocution

- Use only non-conductive ladders near electricity
- Stay at least 10 feet from overhead power lines
- Be aware of all electrical hazards in your work area
