# Roof Work Safety

Source: https://usi.how/osha-10-construction/roof-work-safety

## Types of Roof Hazards

### Fall Hazards

- Roof edges
- Skylights and openings
- Deteriorated roofing materials
- Steep slopes
- Ladder access points
- Unexpected changes in elevation
 

### Other Hazards

- Electrical (overhead power lines)
- Heat stress
- Slip hazards (moisture, moss, debris)
- Wind and weather conditions
- Hot asphalt or tar
- Tool-related injuries
 

## Fall Protection Requirements

### Low-Slope Roofs (4:12 pitch or less)

For work 6 feet or more above a lower level, use one of these:

- Guardrail systems
- Safety net systems
- Personal fall arrest systems
- Warning line system (at least 6 feet from edge)
- Warning line and safety monitor for work between warning line and edge
 

### Steep Roofs (greater than a 4:12 pitch)

For work 6 feet or more above a lower level, use one of these:

- Guardrail systems with toeboards
- Safety net systems
- Personal fall arrest systems
 

### Residential Construction

- Fall protection required at 6 feet
- Use conventional fall protection when feasible
- Written fall protection plan needed if conventional systems create greater hazard
 

## Personal Fall Arrest Systems

When using a harness and lanyard on roofs:

- Anchor points must support 5,000 pounds per worker
- Keep fall distance as short as possible
- Prevent swing falls by working close to anchor points
- Never tie off to vents, pipes, or chimneys unless verified as anchors
- Inspect all components before each use
- Calculate fall clearance to ensure lanyard won't allow ground contact
 

## Warning Line Systems

If using warning lines:

- Set up at least 6 feet from roof edge
- Use stanchions that can withstand 16 pounds of force
- Mark line with high-visibility material
- Set line height between 34 and 39 inches
- Flag line at 6-foot intervals or less
- Must be able to withstand 500 pounds of force
 

## Safety Monitor System

When a safety monitor is used:

- Must be a competent person
- Must be on same roof level as workers
- Must be close enough for direct communication
- Must have no other duties
- Can only monitor workers in designated area
- Workers must obey monitor's warnings immediately
 

## Hole and Skylight Protection

All roof holes and skylights must be protected by:

- Guardrail systems around the hole
- Covers secured over the hole (must support 2x anticipated load)
- Personal fall arrest systems for workers near holes
- Never sit or step on skylights (they may not support your weight)
 

## Safe Ladder Use for Roof Access

- Extend ladder at least 3 feet above roof edge
- Secure top and bottom of ladder
- Use proper angle (4:1 ratio)
- Keep three points of contact when climbing
- Never carry tools in hands while climbing
- Set up on firm, level ground
- Face ladder when climbing
 

## Weather Considerations

### Rain and Moisture

- Postpone work when possible
- Use slip-resistant footwear
- Clean mud from boots before climbing
- Use extra caution on wet surfaces
 

### Wind

- Secure materials to prevent blowing off
- Don't carry large materials in high winds
- Consider stopping work when winds exceed 25 mph
- Be aware of changing wind conditions
 

### Heat

- Take frequent breaks in shade
- Drink water regularly
- Watch coworkers for heat illness signs
- Schedule work during cooler parts of day
- Wear light-colored, breathable clothing
 

### Lightning

- Stop work during thunderstorms
- Seek proper shelter (not under trees)
- Wait 30 minutes after last thunder before resuming
 

## Roof Material Hazards

### Asphalt Shingles

- Sharp edges can cause cuts
- Hot weather makes shingles soft and slippery
- Loose granules create slip hazards
 

### Metal Roofing

- Edges can be extremely sharp
- Becomes very slippery when wet
- Can be dented by improper foot placement
 

### Tile or Slate

- Brittle and can break under weight
- Creates falling debris hazard
- Requires specific walking patterns
 

### Built-Up or Tar Roofs

- Hot asphalt can cause severe burns
- Fumes may be hazardous
- Surface may be soft in hot weather
 

## Material Handling on Roofs

- Stage materials flat and away from edges
- Distribute weight evenly across roof structure
- Use roof jacks on steep slopes
- Never throw materials off roof
- Use proper lifting techniques
- Consider mechanical lifting for heavy materials
 

## Tool Safety on Roofs

- Secure tools to prevent drops and falls
- Use tool lanyards when working near edges
- Keep electrical cords away from sharp edges
- Maintain clean, organized work area
- Put tools down on level surfaces
